Silvercrest SRWB 1000 A1 Instrucciones De Uso página 12

Fig. 1
6) Hold the brush in the coiled hair for a few seconds. The duration affects
the strength of the styling effect. Other factors must be taken into account,
such as the thickness of the coiled strand, the hair texture or the set speed/
temperature level. Start with a short duration and increase if necessary until
the desired styling effect is achieved or the hair is completely dry. Note,
however, that hair can be damaged if exposed to high heat for excessive
periods of time.
7) To uncoil the strand again, press the opposite rotation button 2 /7 .
At the same time, gently pull the appliance downwards to release the round
brush 8/9 from the strand.
CAUTION! If hair is caught in the bristles of the round brush 8/9, imme-
diately release the rotation button 2 /7 . Make sure that you slide the
level switch 3 back to the position "0". Then carefully remove the hairs from
the bristles, e.g. with your fingers.
The coating of the round brush 8/9 can become very hot during
operation. Therefore, only hold the round brush 8/9 by the plastic ends
and hold the appliance by the handle.
Note: Start with the lower strands of hair and then style strand by strand
until the desired result is achieved.
Counteract the twisting movement a little and bring slight tension into the
strand by pulling the round brush 8/9 very slightly downwards. This
requires some practice. Immediately release the rotation button 2 /7
if the round brush 8/9 rotates too fast and always before it reaches the
hairline.
You can also achieve more fullness at the hairline by simply holding the
round brush 8/9 for a few seconds just below the strand at the hairline
(see Fig. 2). Do this without the rotation function, otherwise the hair will get
caught in the bristles!
8) Switch off the appliance by moving the level switch 3 back to "O".
SRWB 1000 A1
Fig. 2
GB │ IE │ 9 ■