Publicidad
Idiomas disponibles
Idiomas disponibles
which consists o f a calibrated anglequadrant (I) anda bevel
adjustment
lever (H).The angle q uadrant allows forcoarse adjustment
(N)orfineadjustment
(O)toachieve better accuracy incutting.
TOSETTHE S AW FOR A BEVEL C UT
1.Lift t hebevel adjustment
lever ( H) and tiltfoot p late tothedesired
angle byaligning thepointer withthedesired angle mark.
2.Push thebevel adjustment lever d own andtighten s ecurely to
lock theangle.
Foot Plate
Adjustment
for 90 ° Cuts
IF ADD,TIONAL
ADJUSTMENT IS NEEDED
1. Adjust the saw to 0 ° bevel.
FaG.7
2. Retract blade guard. Place the saw on
blade side.
3. Lift bevel adjustment lever. Place a square
against the blade and foot plate to adjust
the 90 ° setting.
4. Move the adjustment screw, located on the bottom of the foot
plate (Fig. 7), so that the foot plate will stop at the proper angle.
5. Confirm the accuracy of the setting by checking the squareness
of an actual cut on a scrap piece of material.
Kerr
Indicator
(Fig.
8)
The front of the saw foot plate (D) has a 0° ken' indicator (F) and a
45 ° ken' indicator (G) for vertical and bevel cutting.The kerf indicators
enable you to guide the saw along the cutting lines penciled on the
workpiece.
The indicator aligns with the left (outer) side of the saw blade. The
moving blade making the slot or "ken'" cut falls to the right of the
indicator. Position the saw along the penciled cutting line so that the
ken' falls into the waste or surplus material. Marking indicators on
the front of the foot plate are at 1/2" (13 mm) intervals for additional
cutting guides.
FIG. 8
G
F
Ken' indicators (P) are also located on the inside of the foot plate to
keep the saw square when cutting.
OPERATION
_&WARNING: To reduce
the risk
of serious
personal
injury,
turn tool off and disconnect
tool from power
source
before
making any adjustments or removing/installing
attachments
or
accessories.
iMPORTANT: Always make sure the depth adjustment locking lever
is in the down position before operating saw.
Trigger
Switch
(Fig.
1)
_ WARNING: To reduce the risk of serious personal
injury, hold
saw with both hands when starting
the saw to avoid kickback.
Press the trigger switch (A) to turn the tool on. Release the trigger
switch to turn the tool off.
NOTE: This tool has no provision to lock the trigger in the on position
and should never be locked on by any other means.
Changing
Blades
(Fig.
1, 9-12)
iMPORTANT:
Most replacement
blades come with a round arbor
center opening which must be knocked out so a diamond-shaped
Publicidad
