Publicidad
Idiomas disponibles
Idiomas disponibles
5. Replace the oil plug and tighten securely.
6. Dispose of oil according to local, state and federal laws and
regulations.
Brushes
(Fig.
19)
Inspect
carbon
brushes
regularly
by
FIG. 19
unplugging the saw, removing the end cap
(W) located above the depth adjustment
lever
(B)
and
withdrawing
the
brush
assembly. Keep brushes clean and sliding
freely in their guides. Always replace a used
brush in the same orientation in the holder
as it was prior to removal.
Carbon
brushes
have varying
symbols
stamped into their sides, and if either brush
is worn down to the line closest to the spring, the brushes must
be replaced. Use only identical
DEWALT brushes.
New brush
assemblies
are available
at your
local service
center. Always
replace the end cap after inspecting or servicing brushes.The tool
should be allowed to "run in" (run at no load without a blade) for
5 minutes before use to seat new brushes. While "running in "DO
NOT TIE, TAPE, OR OTHERWISE LOCK THE TRIGGER SWITCH
ON. HOLD BY HAND ONLY.
Accessories
_,WARNING:
Since accessories,
other
than those offered
by
DEWALT, have not been tested with this product,
use of such
accessories
with this tool could be hazardous. To reduce the risk of
injury, only DEWALT, recommended
accessories
should be used
with this product.
Recommended
accessories for use with your tool are available at
extra cost from your local service center. If you need any assistance in
locating any accessory, please contact DEWALT Industrial Tool Co.,
701 East Joppa Road, Baltimore, MD 21286, call 1-800-4-DEWALT
(1-800-433-9258)
or visit our website www.dewalt.com.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments
(including
brush inspection
and replacement)
should
be performed
by a DEWALT factory service
center,
a
DEWALT authorized
service
center
or other
qualified
service
personnel. Always use identical replacement parts.
Three
Year
Limited
Warranty
DEWALT will repair, without charge, any defects due to faulty
materials or workmanship for three years from the date of purchase.
This warranty does not cover part failure due to normal wear or tool
abuse. For further detail of warranty coverage and warranty repair
information, visit www.dewalt.com
or call 1-800-4-DEWALT (1-800-
433-9258). This warranty does not apply to accessories or damage
caused where repairs have been made or attempted by others. This
warranty gives you specific legal rights and you may have other
rights which vary in certain states or provinces.
In addition to the warranty, DEWALT tools are covered by our:
1 YEAR FREE SERVICE
DEWALT will maintain the tool and replace worn parts caused by
normal use, for free, any time during the first year after purchase.
90 DAY MONEY BACK GUARANTEE
If you are not completely
satisfied with the performance
of your
DEWALT Power Tool, Laser, or Nailer for any reason, you can return
it within 90 days from the date of purchase with a receipt for a full
refund - no questions asked.
16
Publicidad
