Publicidad
Idiomas disponibles
Idiomas disponibles
5. With tank drain facing you, take caster foot marked with the letter A and
place in slot on left side of tank also marked with the letter A and secure
with screw provided.
6. Take caster foot marked with the letter B and place in slot on right side of
tank also marked with the letter B and secure with screw provided.
7. If flat washers are included in hardware pack place flat washer over stem of caster before installing
casters into feet. NOTE: Flat washers are not required with all units.
8. Insert casters into feet by placing stem of caster into holes provided. Apply
pressure and twisting motion until casters snap into place. Return tank to
upright position.
REAR WHEEL DOLLY/TOOL HOLDER AND FRONT CASTER FEET ASSEMBLY
(Not standard with all models)
You will find two casters, two large rear wheels, one axle, rear dolly/basket, two caster feet, four screws,
two washers, two hair pin clips.
Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down so that the
bottom is facing up.
2. Place one hair pin clip in one end of axle. Slide one washer down
the length of the axle to rest on the hair pin clip. Slide wheel
onto axle next to washer. Be sure flat side of wheel hub is facing
outward.
3. Slide axle through holes provided in dolly/basket.
4. Slide remaining wheel then washer onto axle. Insert hair pin clip into
remaining hole in axle to hold wheel in place.
5. Take rear dolly assembly and place into slots (on rear of tank opposite
drain) and secure with screws provided.
PAGE 6
Publicidad
