fluidra FSN-05 Manual De Instrucciones página 25

On standby or running mode, press
Note : the heat pump can running only if the water circle/filtration system is running.
6.6 Automatic start/stop the heat pump
To set the time to start the unit
Press to set the time to start the unit, then press
start
5 minutes after the water pump).
Press again to store the new data.
To set the time to stop the unit
Press to set the time to stop running, then press
stop
5 minutes before the water pump).
Press again to store the new data.
6.7 Cancel the automatic start/stop
To cancel the automatic starter
Press , then press
To cancel the automatic starter
Press , then press
Note : If the water filtration system is stop before the heat pump, the unit will shut down (security
condition) and the code EE3 or ON advertise on the controller.
It is important to program the heat pump link the time program of the water filtration system.
For restart the heat pump, turn off and turn on the electrical power supply to restart the unit.
6.8. Running data setting
6.8.1 How to check the parameters
On standby or running mode, long press
parameters (from 0 to H, see operation parameter table).
6.8.2 How to adjust the parameters (Can only adjust on standby mode)
1) Long press
parameter table) you want to adjust.
2) Then press
3) Then press
,
,
for 10 seconds, press
or to adjust the parameter, press
or select the other datas you want to adjust, repeat above operation.
and to adjust the desired water temperature
or
or
light off and the automatic start is off.
light off and the automatic stop is off.
for 10 seconds, then press
again to select the data (from 0 to L, see operation
21
to adjust the time (set the time for
to adjust the time (set the time for
or
again to store the new data.
to check the