Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustments (Continued)
Adjustment menu
AO) Signal : Use the F and $È) keys to select either the rear panel input terminal port A
(Mini D-Sub type) or Port B (BNC) type.
This displays the input synchronization signal frequency.
information on the input screen mode (resolution, horizontal and vertical
synchronization frequency) will be displayed on the display monitor. There are
occasions sometimes when some screen modes in use do not display any
resolution. Direct display allows this to be displayed on screen by pressing
the (2) key even when the menu screen is not displayed.
Self-Test menu (No Signal screen)
This display indicates that the monitor is operating normally.
When one of the following conditions occurs, press one of the 4 operation keys to call the
appropriate display.
No
Signal
Error
ÍH --.—kH2
fH 100.0kHz
fV --.--
Hz
fV 170.0 Hz
Port
©
Port &
©
No signal ( the computer is not connected,
The horizontal or vertical sync. signal are
the mains power to the computer is
outside of the permitted range (the value of
disconnected or the input connector in
the horizontal sync. signal will be displayed
use may be deselected).
in red and the value of the vertical sync.
signal will be displayed in white).
Pedestal removal
Observe the following instructions if the unit is to be used with the display stand removed.
Repeat this procedure in the reverse order if the display stand is to be reattached.
Grasp the bottom of the display stand as
indicated in the illustration.
QT A
AEE
Apply pressure with your fingers to the area
shown in the illustration and lift the stand
slightly in an upward direction.
This will release the lock.
E Once the lock has been
released, remove your fingers
and firmly lift upwards at an
O Place the unit on top of
the computer to be used
or on a tabletop.
E This will separate the
stand from the main
unit.
Store the display stand in
the box or other receptacle
in which the computer was
purchased.
I
Y)
cual
O
=
uJ
13
Publicidad
