Publicidad
Idiomas disponibles
Idiomas disponibles
Precautions
1) Installation
¢ Install the monitor in a well ventilated place. Avoid exposing to direct sunlight, a
heater, or any other heat source. Heat will adversely affect the cabinets and the pants
inside.
e Position the display unit so that the holes in the cabinet will not be blocked during use.
¢ Keep the display unit away from the kitchen, bathroom, washing machine, or other
sources of exposed to water, steam or moisture.
+ In order to use the display unit safely, use only the supplied AC Power cord. The AC
Power cord must be used with a properly grounded and polarized power supply
socket. The AC Power cord supplied is for the USA (UL) and Canada (CSA) for use
with the display unit. For use in other countries, make sure the AC Power cord meets
the safety standards of the country.
* Place the AC Power cord where it will not be subject to stress.
+ Use only Panasonic provided accessories or the exact equivalent.
2) Usage
e Pulling on the AC Power cord or VGA Signal Cable can damage the display unit
(monitor) and can cause the unit to fall and possibly cause personal injury.
e Receiving trouble.
if there is a television set or other display unit nearby, keep your display unit as far
away trom it as possible. Mutual interference can cause image distortion or noise.
* Long exposure to rubber or vinyl products can stain the cabinet.
+ Keep the monitor from physical shock when moving. Be careful of the Cathode Ray
Tube (CRT).
+ Do not place anything on the monitor.
* Also take good care of the AC Power cord:
Do not place any objects on the AC Power cord. Do not attempt to extend, shorten or
tie it into a knot.
3) Product Care
¢ Prior to cleaning your display unit, disconnect the AC Power cord and the VGA Signal
Cable or BNC Cable from the display unit.
+ Use a clean, soft, dry cloth to clean the outside of the monitor or the CRT surface.
lf the monitor or CRT surface is very dirty, wet a clean, soft cloth with neutral
detergent (such as dishwashing detergent) and water, squeeze it tight until almost dry,
wipe the monitor or CRT surface with it, and finish by wiping with a clean dry cloth. Do
not use any solvents.
+ Do not rub or strike the monitor with anything hard or harsh as this may scratch, mar
or damage the monitor permanently.
* Do not use a chemical duster or polish-cleaner because it can adversely affect the unit
and peel the paint coat.
Publicidad
