Proficook PC-WKS 1167 G Manual De Instrucciones página 11

We recommend disconnecting the appliance from the
power supply when you are away from home to prevent
unintentional switching on while you are on the road!
System Requirement for Use of the App
• iOs 11.0 or higher
• Android 5.0 or higher
Commissioning via the App
The appliance can only be operated with 2.4 GHz routers.
5 GHz routers are not supported.
1. Install the "Smart Life - Smart Living" app. Create a user
account.
2. Activate the Wi-Fi function in the settings of your appli-
ance.
3. Place the appliance at a distance of about 5 meters to
your router.
4. Press and hold the button for about 5 seconds. The
indicator lamp flashes quickly.
5. Launch the app and select " + ".
6. Select the "Water kettle" menu and follow the instructions
on the display.
7. After the appliance has been successfully connected, the
indicator lamp of the button lights up. Now you can
operate the appliance using the app.
Disconnecting the Wi-Fi
If you want to disconnect the existing Wi-Fi connection,
proceed as follows:
1. Press and hold the button
2. The Wi-Fi connection will be disconnected and the appli-
ance is removed from the app at the same time.
If you want to re-establish the WLAN connection, proceed
as described in the paragraph "Commissioning via the App".
Using the Appliance
1. Place the appliance on a flat surface.
2. Take the cover and lift it up by using the knob.
3. Then fill in the water (max. 1.5 litre). You can read the
filling level on the water level indicator of the kettle.
- Always use fresh, cold water.
- The water level must be between the MAX and MIN
marks.
4. Place the cover back on. It must audibly engage. Always
ensure that the lid is tightly closed.
5. Place the kettle flush on the base.
Operation
Select a temperature using the buttons 8 to 10. The lamp
starts flashing and the appliance will turn on.
• When the temperature is reached, you will hear a beep.
• The lamp on the temperature button lights up. The ap-
pliance will now keep the temperature stable for 2 hours
and then switch off.
PC-WKS1167G_IM_02.2023
for about 5 seconds.
• The keep warm function remains active even if you re-
move the jug from the base for a maximum of 3 minutes.
If the jug is not put back on within these 3 minutes, a
beep will be heard. The appliance switches to standby
mode.
• Not for 100 °C! The keep warm function cannot be
combined with this temperature.
• Quick start:
- Press the button after putting the jug on to boil.
- The water will be heated to 100 °C.
Tea Strainer
The tea strainer should only be immersed in water if the
desired temperature has been reached.
1. Bring 1.0 litres (max.) of water to the boil. To prepare tea,
refer to the "TeaMax" mark. After boiling water you may
insert the tea strainer into the lid of the kettle. See the
illustration.
2. Remove the cover.
3. Dose your tea and insert the tea strainer into the lid.
4. Put the cover back on the lid until it audibly snaps into
place.
WARNING: Risk of burns!
The tea strainer becomes hot! Be careful when removing.
If necessary, use a potholder. The tea strainer will con-
tinue to drip!
Ending / Terminating Operation
There are two options to interrupt the boiling process or to
terminate it:
1) The appliance will switch off after the boiling process.
2) Press the button in order to end the boiling process.
• The appliance switches to standby mode.
- Always shut off the appliance before removing it from
the base! The contacts on the base are unsuitable for
interrupting the current.
- Also ensure that it is turned off when you set it back
onto the base!
• Pull the mains plug out of the socket.
• Emptying the water container.
- Always hold the appliance by the handle.
- When pouring the water out, keep the lid closed.
- Open the cover from the lid by using the knob only.
- Hold the cover by using the knob in order to put it
back on the lid.
• During operation the housing becomes hot. Do not touch
it and allow the appliance to cool down before storing it
away.
11
17.02.23