Simplicity Scout Manual Del Propietário página 11

Using the Cord Rewind Button
and Standby On/Off Button
Standby On/Off Button (Fig 10)
1. Unwind a sufficient length of power
cord. The yellow mark on the power
cord shows the recommended cord
length. DO NOT extend the cord
beyond the red mark.
2. Insert the cord into the outlet.
3. Press the Standby On/Off button to
put the vacuum into Standby Mode.
4. To switch On the cleaner:
• Press the Power Decrease or Power
Increase buttons on the Digital Power
Control panel.
Rewind (Fig 11)
1. Press the On/Off button to switch off
the vacuum.
2. Unplug the cord from the power
outlet.
3. To rewind the power cord, press the
rewind button with one hand and
guide the cord with the other hand to
ensure that the power cord does not
whip.
Note: Do not unplug by pulling on the
power cord. To unplug, grasp the power
plug not the power cord and gently pull
the power plug from the power outlet
Vacuum Cleaner Storage
When not in use, ensure that the cleaner
is disconnected from the power supply
and that the cable is fully retracted. The
combination floor tool can be stored in
the floor tool holders. Other floor tools
must be stored separately.
INSTRUCTIONS
(Fig 10)
(Fig 11)
9