Publicidad
Idiomas disponibles
Idiomas disponibles
R A N G E R
INFLATION AND ASSEMBLY PROCESS
WARNING: Please only use the pump provided or other recommended pumps. DO NOT use
an air compressor as you will risk over-inflating the board and severely damaging your Kayak
beyond repair. Your warranty will be void in the event of damage via over-inflation.
●
First inflate the inner floor chamber by connecting the air tap on your
pump to the inflation valve on your Kayak. Firmly push the air tap
inwards and twist clockwise to secure the connection. Figure 1
●
Pump the side chambers on the kayak body halfway. To inflate this is
the same method as the pervious step.
●
Insert the drop-stitch floor into the kayak body and push under the half
inflated side chambers.
●
Fully inflate the side chambers to the PSI indicatted around the valve.
●
Then inflate the inner chamber valve in the center of the board to the
recommended PSI noted around the valve.
Publicidad
