Amica 10143.4eETsDpHaQS Manual De Instrucciones página 46

OPERATION
Electronic programmer*
— select the mode of operation
MENU
> — higher setting sensor
<
— lower setting sensor
— appliance on indicator
— Kitchen timer
— Duration
— End Time
Set current time
When the appliance is plugged into the elec-
trical mains supply, or when power is restored
after power outage, the digital display will
show flashing 0.00.
l Touch and hold
touch < / >) until you will see
display and the dot below the symbol is
flashing,
l Touch < / > within 7 seconds to set the
current time.
To store the new time setting, wait approxi-
mately 7 seconds after time has been set.
The dot below the
You can adjust the time later. To do this touch
< / > simultaneously and adjust the current
time while the dot below the
flashing.
Note:
The oven can be turned on when you see the
symbol on the display.
*optional
((or simultaneously
MENU
on the
symbol will stop flashing.
symbol is
Kitchen Timer
You can active the Kitchen Timer at any time,
regardless of the status of other functions.
The Kitchen Timer can be set from 1 minute
up to 23 hours and 59 minutes.
To set the Kitchen Timer:
, then the display will show
l touch
MENU
blinking :
l use the < / >, sensors to set the Kitchen
Timer. The display will show the set time
and Kitchen Timer symbol
set time elapses, alarm sounds and the
icon flashes,
l Touch and hold < / > or
alarm. The will be off and the display will
show the current time after approximately
7 seconds.
Note!
If no button is touched, alarm will turn off
automatically after approximately 7 minutes.
46
. Once the
to mute the
MENU