Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Tips
•
Before opening LP cylinder valve, check the coupling nut for
tightness.
•
When grill is not in use, turn off all control knobs and LP cylinder
valve.
•
Never move grill while in operation or still hot.
•
Use long-handled barbecue utensils and oven mitts to avoid burns
and splatters.
•
Maximum load for side shelf is 10 Ibs.
•
The grease tray must be inserted into grill and emptied after each
use. Do not remove grease tray until grill has completely cooled.
•
Clean grill often, preferably after each cookout. If a bristle brush is
used to clean any of the grill cooking surfaces, ensure no loose
bristles remain on cooking surfaces prior to grilling. It is not
recommendedto clean cooking surfaces while grill is hot.
•
If you notice grease or other hot material dripping from grill
Determine the cause, correct it, then clean and inspect valve,
Keep ventilation openings in cylinder enclosure (grill cart) free and
clear of debris.
•
Do not store objects or materials inside the grill cart enclosure that
would block the flow of combustion air to the undersideof either
the control panel or the firebox bowl.
•
The regulator may make a humming or whistling noise during
operation. This will not affect safety or use of grill.
•
If you have a grill problem see the "TroubleshootingSection':
•
If the regulatorfrosts, turn off grill and LP cylinder valve
immediately.This indicatesa problem with the cylinder and it
should not be used on any product.
!
I
Putting out grease fires by closing the lid is not possible.
Grills are well ventilated for safety reasons.
Do not use water on a grease fire. Personal injury may
result. If a grease fire develops, turn knobs and LP
cylinder off.
Do not leave grill unattendedwhile preheating or burning
off food residue on HI. If grill has not been regularly
cleaned, a grease fire can occur that may damage the
product.
IVlain Burner Ignitor Lighting
• Do not lean over grill while lighting.
1. Open lid during lighting.
2. Turn ON valve from source or tank.
3. Push and turn Ignition Burner control knob to _
HI and
immediately press and hold Electronic Ignition button.
4. If ignition does NOT occur in 5 seconds, turn Ignition Burner
control knob OFF, wait 5 minutes, and repeat the lighting
instructions.
5. To Light Other Burners turn control knob to HI.
If ignitor does not work, follow Match Lighting instructions.
After Lighting: Turn knobs to HI position for 5 minutes to
pre-heat grill. Then turn knob to desired setting for cooking.
146.23770310 • 7
Publicidad
