Publicidad
Idiomas disponibles
Idiomas disponibles
Before you start
1. Battery
2. Battery charge status
button
Fitting and removing the battery
The blower will operate when the battery is installed, the power indicator LED is lit. Make sure the blower is properly positioned
to prevent loss of control and possible serious injury.
NOTE
The battery comes partially charged from the factory and needs to be fully charged before first use.
1. Battery
2. Ridge
1. Complete position
2. Uncompleted position
3. LED display
WARNING
3. Battery pack latch
3. Battery pack latch
4. Battery pack
4.
When charging is complete, battery LED will remain
GREEN.
5.
Verify battery is fully charged by removing battery from
charger, then pressing battery charge status button, and
checking LED display.
One green light indicates that the battery has 0-25%
charge.
Two green lights indicate that the battery has 25-50%
charge.
Three green lights indicate that the battery has 50-75%
charge.
Four green lights indicate that the battery has 75-100%
charge.
6.
Disconnect battery charger from power supply.
Fitting the battery
1.
Release trigger switch and move the cruise control lever
completely forward to the stop position.
2.
Make sure power to unit is turned off.
3.
Align ridges on battery with groove on blower, and insert bat-
tery until battery pack latch gets in the complete position.
IMPORTANT
Before using the blower, make sure that battery is set cor-
rectly with battery pack latch in the complete position.
NOTE
Battery pack latch is in the complete position when battery
pack latch is correctly engaged.
16
Publicidad
