Tribest slowstar SW-2020 Manual De Uso página 16

TIPS FOR SILICONE PARTS
-Silicone parts can be disassembled and washed.
-Fully dry the silicone parts after washing.
-Please check if the silicone parts are assembled correctly.
*Juice may leak if you do not assemble the silicone parts properly.
• Silicone Blade
1. Disassembly: Hold the Tail portion (2 in the drawing)
of the silicone blade and push upward to the middle
(3 in the drawing) of the blade slot, then pull outward.
2. Assembly:
1) Insert the Head portion (1 in the drawing) into the
middle of the blade slot in the Rotator (3 in the
drawing), making sure the Silcone Blade groove
and the Rotator blade slot groove fit together, and
slide the Head upward .
2) Insert the Tail portion into the middle of the blade slot,
making sure the Silcone Blade groove and the Rotator
blade slot groove fit together, and slide the Tail downward.
*After inserting pull the Silicone Blade tabs on the inside to
make sure it is securely assembled.
• Sealing ring
1. Disassembly: Push from the bottom side of
the Auger Housing (smaller silicone ring) for
easy cleaning.
2. Assembly: After it is thoroughly dried, put the
sealing ring properly back in its place. Push the
sealing ring (with the larger side facing up) back
in place from the inside of the Auger Housing.
• Pressure Plug
After washing, put the Pressure Plug
in correctly as shown in the picture
16
Silicone
Blade Groove
Blade Slot
Groove