Publicidad
Idiomas disponibles
Idiomas disponibles
English
(2) Turn the USB power switch ON (Fig. 8)
When you turn the USB power switch ON, the USB
power indicator lamp will light up.
Rubber cover
USB cable
USB port
(3) Connect the USB cable. (Fig. 8)
Pull back the rubber cover and fi rmly plug in a
commercially available USB cable (appropriate to the
device being charged) into the USB port.
○ When the power cord is not plugged into an outlet and
the battery runs out of power, power output will stop
and the USB power indicator lamp will shut off .
○ When the USB power indicator lamp goes out, change
the battery or plug the power cord into an electrical
outlet.
(4) When charging is completed
○ The USB power indicator lamp will not go out when a
USB device has been completely charged.
To verify charge status, check the USB device.
○ Turn the USB power switch OFF and unplug the power
cord from the electrical outlet. (Fig. 8)
○ Remove the battery from the charger and place the
rubber cover over the USB port.
BEFORE USE
Check the work area to make sure that it is clear of debris
and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
OPERATION
1. Selecting the socket matched to the bolt
Be sure to use a socket which is matched to the bolt
to be tightened. Using an improper socket will not only
result in insuffi cient tightening but also in damage to
the socket or nut.
A worn or deformed hex. or square-holed socket will
not give an adequate tightness for fi tting to the nut
or anvil, consequently resulting in loss of tightening
torque.
Pay attention to wear of socket hole, and replace
before further wear has developed.
14
USB power
switch
USB power
indicator lamp
Fig. 8
2. Installing a socket
(1) Align the square portions of the socket and the anvil
with each other.
(2) Make sure to fi rmly install the socket by pushing it all
the way into the anvil.
(3) When removing the socket, pull it out of the anvil.
Hexagonal
socket
CAUTION
● Please
use
the
which are listed in the operations manual and
metabo HPT's catalog. Accidents or injuries
could result from not doing so.
● Make sure to fi rmly install the socket in the anvil.
If the socket is not fi rmly installed it might come
out and cause injuries.
3. Confi rm that the battery is mounted correctly.
4. Check the rotational direction
The bit rotates clockwise (viewed from the rear side)
by pushing the R-side of the push button.
The L-side of the push button is pushed to turn the
bit counterclockwise. (See Fig. 10). (The
marks are engraved on the body.)
marks
Push
CAUTION
The push button can not be switched while the
impact wrench is turning. To switch the push
button, stop the impact wrench, then set the
push button.
Anvil
Fig. 9
designated
attachments
and
marks
Push
Push button
Trigger switch
Fig. 10
Publicidad
