Publicidad
Idiomas disponibles
Idiomas disponibles
(1) High / Low mode selector switch (Fig. 16)
The tightening mode switches between 4 diff erent
rotation speeds each time the High / Low mode
selector switch is pressed.
1
2
(2) Auto stop mode selector switch (Fig. 17)
Each time the auto stop mode selector switch is
pressed, the auto stop function will switch between
ON and OFF.
○ When auto stop is OFF (auto stop mode indicator
lamp is OFF):
When the trigger switch is pulled, the power tool will
continue to apply impact. (Will not auto stop)
Tightening mode selector function settings
Rotation speed
(/min)
1,500
1,800
2,100
2,400
1,500
1,800
2,100
2,400
3
4
Fig. 16
High / Low
mode
Mode 1
Mode 2
Mode 3
Mode 4
Mode 1
Mode 2
Mode 3
Mode 4
○ When auto stop is ON (auto stop mode indicator lamp
is ON):
When the trigger switch is pulled, the power tool will
apply impact for a preset amount of time and then
auto stop.
NOTE
○ The appropriate mode diff ers depending on the bolt
and the material being screwed. Tighten in a few test
bolts and adjust the mode setting accordingly.
○ The tightening mode selector function can only be set
after the battery has been installed in the wrench and
the trigger switch has been pulled once.
Auto stop mode
(Auto Stop Time)
For work that requires fi ne adjustments such
as when tightening small diameter bolts.
OFF
For work that requires the power to be
suppressed during tightening.
For work that requires power and speed
during tightening.
Approx.
0.5 sec.
Tasks including the temporary fastening of
wheel nuts for vehicles or pipe fi ttings
Approx.
1 sec.
ON
Approx.
Temporary fastening of steel frames, etc.
1.5 sec.
Temporary fastening of heavy machinery,
Approx.
2 sec.
bridges, etc.
English
Fig. 17
Use
17
Publicidad
