Publicidad
Idiomas disponibles
Idiomas disponibles
English
Remaining battery
indicator lamp
Display panel
State of lamp
Lights ;
The battery remaining power is
over 75%.
Lights ;
The battery remaining power is
50%–75%.
Lights ;
The battery remaining power is
25%–50%.
Lights ;
The battery remaining power is
less than 25%.
Blinks ;
The battery remaining power
is nearly empty. Recharge the
battery soonest possible
Blinks ;
Output suspended due to high
temperature. Remove the
battery from the tool and allow
it to fully cool down.
Blinks ;
Output suspended due to
failure or malfunction. The
problem may be the battery so
please contact your dealer.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
NOTE
Do not give a strong shock to the display panel or
break it. It may lead to a trouble.
16
Remaining battery
indicator switch
Fig. 13
Table 5
Battery Remaining Power
9. How to use the LED light
While the switch is pulled, the LED light will
automatically light up the tip portion of the tool.
(Fig. 14)
The LED light will automatically turn off 10 seconds
after the switch is released.
CAUTION
● Do not expose directly your eye to the light by
looking into the LED light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
10. Tightening mode selector function
CAUTION
● Do not subject the switch panel to shock or
damage.
● Select tightening mode while the trigger switch
is released. Failure to do so could result in
malfunction.
Tightening torque can be adjusted according to the type
of work by combined use of the High / Low mode selector
switch and the auto stop mode selector switch. (Fig. 15)
High / Low mode
Auto stop mode
selector switch
selector switch
Trigger switch
Fig. 14
Fig. 15
Publicidad
