Briggs & Stratton 020228 Manual Del Usuario página 4

Section 1: Safety Rules
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment to cool before touching.
The pressure washer must be at least 5 feet from structures
having combustible walls and/or other combustible materials.
Keep at least 3 feet of clearance on all sides of pressure
washer for adequate cooling, maintenance and servicing.
Reflective exhaust heat may damage fuel tank causing fire.
Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arrestet_ maintained in
effective worl<ing ordet_ complying to USDA Forest service
standard 5100- I C or later revision. In the State of California a
spark art*ester is required under section 4-442 of the California
Public resources code. Other states may have similar laws.
WARNING
DO NOT wear loose clothing, jewelry or anything that may
be caught in the starter or other rotating parts.
Tie up long hair and remove jewelry.
WHEN ADJUSTING OR MAKING REPAIRSTOYOUR
PRESSURE WASHER
Disconnect sparl< plug wire from sparl< plug and place wire
where it cannot contact spark plug.
tVHENTESTING FOR ENGINE SPARK
Use approved spark plug testen
DO NOT check for spark with sparl< plug removed.
WARNING
Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
CAUTION
DO NOT tamper with governed speed.
DO NOT operate pressure washer" above rated pressure.
DO NOT secure spray gun in open position.
DO NOT leave spray gun unattended while machine is
running.
NEVER use a spray gun which does not have a trigger lock or
trigger guard in place and in working orden
Always be certain spray gun, nozzles and accessories are
correctly attached.
CAUTION
DO NOT point spray gun at glass when using MAX (pin
point) nozzle.
NEVER aim spray gun at plants.
If you have questions about intended use, ask dealer or
contact Briggs & StraEon Power Products.
NEVER operate units with broken or missing parts, or
without protective housing or covers.
DO NOT by-pass any safety device on this machine.
Before starting pressure washer in cold weather, check all
parts of the equipment to be sure ice has not formed there.
NEVER move machine by pulling on high pressure hose. Use
handle provided on unit.
Check fuel system for leaks or signs of deterioration, such as
chafed or spongy hose, loose or missing clamps, or damaged
tank or cap. Correct all defects before operating pressure
washen
This equipment is designed to be used with Briggs & Stratton
Power Products authorized parts ONLY. If equipment is used
with parts that DO NOT comply with minimum specifications,
user assumes all risks and liabilities.
O