Briggs & Stratton 020228 Manual Del Usuario página 9

Operation
HOWTO USE YOUR
PRESSU RE WASH ER
If you have any problems operaung your pressure washer,
please call the pressure washer helpline at 1-800-743-4115.
Pressure Washer Location
Pressure Washer Clearance
WARNING
Operate pressure washer ONLY outdoors.
Keep exhaust gas fl*om entering a confined area through
windows, doors, ventilation intakes or other openings.
DO NOT operate pressure washer inside any building or
enclosure, even if doors or windows
are
open.
The pressure washer must be at least 5 ft. (I 52 cm) from
structures having combustible walls and/or other
combustible materials. Leave at least 3 ft. (92 cm) all around
pressure washer including overhead, for adequate cooling,
maintenance and servicing.
Place pressure washer in a well ventilated area, which will
allow for removal of deadly exhaust gas. DO NOT place
pressure washer where exhaust gas could accumulate and
enter inside or be drawn into a potentially occupied
building. Ensure exhaust gas is kept away from any
windows, doors, ventilation intakes or other openings that
can allow exhaust gas to collect in a confined area
(Figure 7). Prevailing winds and air currents should be taken
into consideration when positioning pressure washer.
Typical Pressure
Washer Shown
Exhaust Port
How to Start Your Pressure Washer
To start your pressure washer for the first time, follow
these instructions step-by-step.This starting information
also applies if you have let the pressure washer sit idle for
at least a day.
I. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.2 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2. Check that high pressure hose is tightly connected to
spray gun and pump. See "Preparing Pressure Washer
for Use" for illustrations.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
CAUTION
* Damage to equipment resulting from failure to follow this
instruction will void warranty.
5. Attach nozzle extension to spray gun (Figure 8).
Tighten by hand.
\
6. Choose ProjectPro TMnozzle you want to use, pull
back on collar of nozzle extension, insert nozzle and
release collanTug on nozzle to make sure it is securely
in place (Figure 9). See "How to Use ProjectPro TM
Nozzle System".
7. Engage trigger loci< on spray gun trigger (Figure I0),
_
_7-r_,
_J , _ / Trigger Loci<
J
O