Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING BATTERY
n_as_ARNING: Do not short battery terml-
y allowing awrench or any other object
to contact both terminals at the same time.
Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected first to
prevent sparking from accidentatgrounding.
1. Lift hood to raised position.
2. Remove terminal cover.
3. Disconnect BLACK battery cable then
RED battery cable and carefully remove
battery from tractor.
4. Install new batterywith terminals in same
position as old battery.
5. Reinstall terminal cover.
6. First connect RED battery cable to posi-
tive (+) battery terminal with bolt and nut
as shown. Tighten securely.
7. Connect BLACK grounding
cable to
negative (-) battery terminalwith remain-
ing bolt and nut. Tighten securely
8. Close hood.
.o0 ,ivo
__ (Black)
,__
CabIe
Terminal
_,,L
L_ .__'_
Cover .
Positive _.-'_
"_,"_._._._
(Red)/
"_.
_
/1
FRONT WHEEL TOE-IN/CAMBER
Your new tractorfront wheel toe-in and cam-
ber is set at the factory and is normal. The
front wheel toe-in and camber are not adjust-
able. If damage has occurred to affect the
factory set front wheeltoe-in or camber, con-
tact a Sears or other qualified service center.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
• Check wiring.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-
in fuse. The fuse holder is located behind
the dash.
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Remove bulb holder fromthe hole in the
backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in the
backside of the grill,
4, Close hood.
TO REMOVE HOOD & GRtLLASSEMBLY
1. Raise hood.
2. Unsnap headlight wire connector,
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. When replacing hood, be sure to recon-
nect the headlight wire connector,
ENGINE
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at
the factor] and adjustment should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual.
TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be neces-
sary. If adjustment is necessary, see engine
manual.
TO ADJUST CARBURETOR
Your carburetor has been preset atthefactory
and adjustment should not be necessary.
However, minor adjustment may be required
to compensate for differences in fuel, tem-
perature, altitude or load. ffthe engine does
need adjustment, see engine manual.
29
Publicidad
