Publicidad
Idiomas disponibles
Idiomas disponibles
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary to insure proper tightness.
ADJUST SEAT
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench
set will make assembly
easier,
Standard
wrench
sizes are listed.
(2) 7/16" wrenches
Utility knife
(1) 1/2" wrench
Tire pressure
gauge
(1) 3/4" wrench
Pliers
(1) 3/4" socket w/drive
ratchet
(1) 9/16" wrench
Flashlight
t. Sit in seat.
2. Lift up adjustment lever (A) and slide seat
until a comfortable position is reached
which allows you to press clutch/brake
pedal all the way down.
3. Release lever to lock seat in position.
When right or left hand is mentioned in this
manual,itmeanswhenyouareintheoperating
position (seated behind the steering wheel).
TO
REMOVE
TRACTOR
FROM
CARTON
UNPACK CARTON
•
Remove all accessible loose parts and
parts cartons from carton.
•
Cut along dotted lines on all four panels
of carton. Remove end panels and lay
side panels flat.
•
Remove mower and packing materials.
•
Check for any additional loose parts or
cartons and remove,
BEFORE
REMOVING
TRACTOR
FROM SKID
TO CHECK BATTERY
1. Lifthood to raised position.
NOTE: if this battery is put intoservice after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of one hour at 6q 0 amps, (See
"BATTERY" in Maintenance section of this
manual for charging instructions).
,
Forbatteryand batterycableinsta!lationsee
"REPLACING BATTERY" inthe "Service
and Adjustments" section inthis manual,
abel
NOTE: You may now roll your tractor off the
skid. Follow the instructions below to remove
the tractor from the skid.
WARNING: Before starting, read, un-
derstand and follow all instructions in the
Operation section of this manual, Be sure
tractor is in a well-ventilated area, Be sure
the area in front of tractor is clear of other
people and objects.
TO ROLL TRACTOR
OFF SKID (See
Operation
section
for location
and
function
of controls)
1, Raise attachment lift lever to its highest
position.
2. Release parking brake by depressing
clutch/brake pedal.
3. Place gearshift lever in neutral position,
4. Roll tractor forward off skid.
Continue with the instructions that follow,
TO INSTALL
MOWER
1. SET PARKING BRAKE LEVER AND
LOWER ATTACHMENT LIFT LEVER
Depress clutch/brake pedal all the way
down and hold.
Pull parking brake lever up and hold,
release pressure from clutch/brake pedal,
then release parking brake lever. Pedal
should remain in brake position. Ensure
parking brake will hold tractor secure.
,,j
Brake Lever
Publicidad
