Troy-Bilt 020240 Manual De Instrucciones página 4

Section 1: Safety Rules
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment to cod before touching.
Keep at least 5 ft. (U52 cm) clearance on all sides of pressure
washer including overhead.
Code of Federa[ Regulation (CFR) Tide 36 Parks, Forests_ and
Public Property requh-e equipment powered by an internal
combustion engine to have a spark arrester_ maintained in
effective working order; complying to USDA Forest service
standard 5100-IC or later revision. In the State of California a
spark attester is required under section 4442 of the California
Public resources code. Other states may have similar laws,
WANNING
. DO NOT wear loose clothin D iewdry or anything that may
be caught in the starter or other rotating parts.
. Tie up long hair and remove jewelry<
WARNING
WHEN ADJUSTING OR MAKING REPAiRSTOYOUR
PRESSURE WASHER
Disconnect spark plug wire from spark plug and place wire
where it cannot con_ct spark plug,
WHENTESTING FOR ENGINE SPARK
Use approved spark plug tester_
DO NOT check for spark with spark plug removed,
WARNING
. AIw,ays wear eye protection when using this equipment or in
vicinity of where equipment is in use.
CAUTION
DO NOT tamper with governed speed.
DO NOT operate pressure washer above rated pressure.
CAUTION
DO NOT secure spray gun in open position.
DO NOT leave spray, gun unattended while machine is
running.
NEVER use a spray gun which does not have a tri88er lock or
trigger guard in place and in working order:
Aiways be certain spray, gun, nozzles and accessories are
correctly, attached.
DO NOT point spray gun at glass when using MAX (pin
point) nozzle.
NEVER aim spray gun at plants,
if you have questions about intended use, ask dealer or
contact Bri88s & Stratton Power Products.
NEVER operate units with broken or missing parts_ or
without protective housing or covers.
DO NOT by-pass any safety device on this machine.
Before starting pressure washer in cold weather, check all
parts of the equipment to be sure ice has not formed there.
NEVER move machine by pulling on high pressure hose. Use
handle provided on unit.
Check fuel system for leaks or signs of deterioration, such as
chafed or spongy hose, loose or missing clamps, or damaged
tank or" cap. Correct aJl defects before operating pressure
washer.
This equipment is designed to be used with Brigs & Stratton
Power Products authorized parts ON L¥. If equipment is used
with parts that DO NOT comply with minimum specificadons,
user assumes all risks and liabilities.