Mitsubishi Electric City Multi PLFY-P VBM-E Serie Manual De Instalación página 12

A 5
(Enlarged)
B Corner panel
C Safety wire
12
A Clamp of the main unit
B Electrical box
C Indoor controler board
D Catch for bell mouth
E Lead wire of grille
A Controller board CN4Y
B Controller board CN6Y
C 2 fasteners 4
D Fastener 4
E i-see sensor corner panel 7
F Rib for grille
G Screw 6
A Button
B
C
D Connector
open the cover.
The lead wire of grille is passed through the catch for bell mouth of the unit
perfectly. The remaining lead wire is tied with clamp of the unit and put the cover of
the unit again with 2 screws.
Note:
Note:
4 ×
*If the corner panels are not attached, they may fall off while the unit is operating.
reverse order to install the intake grille and the corner panel.
corner panel is consistent with the other units regardless of the orientation of the
intake grille. Align the logo on the panel according to the wishes of the customer
as shown in the diagram to the left. (The position of the grille can be changed.)
D Refrigerant piping of the main unit
E Drain piping of the main unit
F Initial position of the corner panel (logo attached)
* Installation in any position is possible.
G Initial position of the levers on the intake grille
here is recommended. (It is not necessary to remove the intake grille when main-
tenance is performed on the electric component box of the main unit.)
H i-see sensor (PLP-6BAE panel)
For PLP-6BAE panel
7 from the side of the electrical box on the unit and make sure to connect them to
the connector of the controller board.
with the fastener 4 so that there is no slack.
of the fastener 4 so that there is no slack.
* Make sure wires are not caught in the cover of electric box. If they are caught,
they will be cut.
the i-see sensor corner panel.
The vanes of the unit can be set and locked in up or down orientations depending
upon the environment of use.
performed using the remote controller. In addition, the actual position of the vanes
may differ from the position indicated on the remote controller.
1
Turn off the main power switch.
2
Disconnect the connector for the vane motor of the vent that you want to lock.
(While pressing the button, remove the connector in the direction indicated by
the arrow as shown in the diagram.) After removing the connector, insulate it with
tape.
It also can be set by remote controller. Refer to 4.7.
and the surface of the ceiling. If there is any gap between the unit and the grille, or
between the grille and the surface of the ceiling, it may cause dew to collect.
does not rotate, review the procedure in "5.6. Installation of i-see sensor corner
panel".
7
1 with screw 6.
-