B) Mounting And Cleaning Pad; Neutralizing; Surfox Turbo Electrolyte Cleaning Solutions - Walter SURFOX TURBO Manual De Usuario

Start-up Procedure
B) Mounting of Cleaning Pad
Squeeze and
Insert Clamp Ring
Insert Cleaning Pad
Press in wand tip
Remove tip with installed pad

Neutralizing

Neutralizing
The SURFOX-N liquid or FT 100 liquid is a specially
formulated cleaner and neutralizer for the SURFOX electrolyte
solutions. It is a powerful ready-to-use formula which leaves
no residue, is non-toxic, solvent free, water-based and
biodegradable.
Directions for cleaning and neutralizing
SURFOX electrolyte cleaning solutions:
1. Remove any excess SURFOX Electrolyte solution using a
soft clean cloth.
2. Spray SURFOX-N liquid or FT-100 on the surface.
3. Wipe dry with a SURFOX POWERCLOTH.
For more information about this product, refer to product SDS.
WARNING! When using SURFOX TURBO, be sure to wipe off
all excess from the surface and clean/neutralize to prevent salt
residues.
Clean the weld using the SURFOX TURBO machine and
SURFOX electrolyte solutions. Work only 2 feet at a time.
Note: the cleaning pad/brush should be kept moist – not
dripping.
1. After weld cleaning, use a clean cloth or paper towel and
wipe the affected area in a squeegee action from left to
right. Then discard the cloth or paper towel.
2. After cleaning the weld with the SURFOX TURBO weld
cleaning machine, the electrolyte solution must be cleaned
and neutralized.
1. Spray the affected area with SURFOX-N liquid or FT-100
cleaner and neutralizer. Allow to sit for 15 seconds on the
surface.
2. Use a SURFOX POWERCLOTH and wipe the affected
area in a squeegee action from left to right.
Note: failure to neutralize or neutralize properly the
SURFOX-T electrolyte solution will result in clouding, hazing
and dulling of the surface.
User's Guide SURFOX TURBO 9
SURFOX electrolyte
hetch due to unproper
neutralization and rinsing