Beyerdynamic MC 930 Instrucciones De Uso página 6

MC 930 — True Condenser Microphone
INSTALLATION AND OPERATION
Connection
� The MC 930 is equipped with a 3-pin XLR connector .
You can connect it to any microphone input with
phantom power (11 - 52 V) with a suitable microphone
cable . Activate phantom power for this purpose .
Caution: Carelessly laid cables are a trip hazard .
�
People can be injured and the microphone
can be damaged .
Operation
The MC 930 has an almost frequency-independent
�
cardioid polar pattern . This means that the
microphone picks up sound primarily from the
front . In order to avoid feedback and noise as much
as possible, you should position the microphone
so that monitor speakers and other sound sources
radiate directly from behind (angle 180°) onto the
microphone . There, the cardioid polar pattern
provides the best possible attenuation .
Adjusting the pre-attenuation
�
For higher sound pressure levels, you can use the
right slide switch on the front of the microphone to
switch on a pre-attenuation of 15 dB (imprint -15 dB) .
Adjusting the low-cut filter
�
If a directional microphone (pressure gradient
receiver) is used for short-range recordings, a
physically induced increase in the low-frequency
sound components occurs, which is refered to a pro-
ximity effect . In order to compensate this effect, the
MC 930 has a switchable low-cut filter below 250 Hz
on the front (left) with 6 dB per octave .
The MC 930 is supplied with the MA-CL 21 microphone
�
clamp for tripods with 3/8" thread . For tripods with
a 5/8" thread, you can unscrew the threaded insert .
Caution: A tripod with an insecure stand can fall
�
over and damage a microphone mounted
on it . Make sure the tripod stands stable .
MAINTENANCE
Use a soft cloth moistened with water to clean the
�
microphone shaft .
� Make sure that no water enters the microphone .
Do not use cleaning agents containing solvents .
�
You can clean the WS 53 wind shield with clear water .
�
Let it completely dry before you use it again .
DISPOSAL
This symbol on the product, in the operating
�
instructions or on the packaging means that
electrical and electronic devices must be
disposed of separately from household waste
at the end of their life cycle .
� Always dispose of used equipment in
accordance with applicable regulations .
� Dealers for electronic equipment are generally
obliged to take back waste electrical/electronic
equipment free of charge . This obligation also
applies to sales via remote communication .
� For further information, please contact the local
authorities or the dealer from whom the product
was purchased .
TROUBLESHOOTING AND SERVICE
Should you have technical problems when using the
�
microphone or should you need more instructions,
please visit our FAQ website at
https://support.beyerdynamic.com
In case of service, please contact authorised service
�
personnel . Never open the microphone yourself, as
this could invalidate all warranty claims . Please visit
our website https://www.beyerdynamic.com for
service and replacement parts .
FURTHER INFORMATION
If you need further information, please visit our
�
website . On our product detail page https://beyerdy-
namic.com/mc-930.html and https://beyerdynamic.
com/mc-930-stereo-set.html you will also find sound
samples .
If you would like to learn more about beyerdynamic
�
microphones for various applications, please visit
https://www.beyerdynamic.com/microphones-ma-
de-in-germany
WARRANTY
beyerdynamic offers a limited warranty of 2 years
on the purchased beyerdynamic product . The exact
warranty conditions can be found on our website at
https://www.beyerdynamic.com/service/warranty
CONFORMITY
Information on the conformity of the product can be
found on our website at https://www.beyerdynamic.
com/downloads
6