Publicidad
Idiomas disponibles
Idiomas disponibles
The content of the packaging should be as follows (* the final content
may vary depending on the model purchased):
Wire shelf (1)
Plastic shelf (1)
User's manual and warranty (1)
3. INSTALLATION
APPLIANCE POSITION
Good ventilation around the refrigerator is required to allow easy
dissipation of heat, freezing high efficiency and low energy
consumption. For this purpose, you should leave around the fridge
enough open space. It is recommended to keep 100 mm between
the back of the refrigerator and the wall at least 100 mm of space
between the sides and the obstacle or wall 200mm above the top
of the appliance and free space in the front to allow opening
doors.
Do not pull or bend the power cable while the device is working.
In addition, it is forbidden to keep the power cable by the
compressor at the back of the refrigerator, as the surface
temperature is quite high when the device is turned on.
Place the appliance away from sources of heat and direct
sunlight.
The ground on which the refrigerator will be placed must be
smooth and solid. Do not place the unit on any soft material such
as foam, plastic, etc. In the event that the appliance is level,
tighten the screws until it succeeds.
It is forbidden for the refrigerator to be placed near any
volatilizable or combustible product such as gas, petrol, alcohol,
lacquer and banana oil. These objects / materials can not be
placed either inside the refrigerator.
The appliance cannot be placed in a horizontal or inclined position
at an angle greater than 45 degrees and cannot be placed in the
opposite position (face down).
41
Publicidad
