Dogtra TOM DAVIS 640C Manual De Instrucciones página 29

3. BUNGEE COLLAR Assembly
Screw
BUNGEE
Clasp
COLLAR
Strap
52
1. To replace the strap,
prepare a new BUNGEE
COLLAR strap and the
screw clasp.
2. Place the logo side facing
up and insert the strap as
shown in the image. (Left
to right if the front of the
receiver is facing you)
3. Insert the strap through
the D-ring that has not
been assembled. Keep
the strap on the flat side
of the D-ring. (Refer to
the opposite side that has
already been assembled.)
4. Bring the strap over the
Inside
Outside
5. The BUNGEE COLLAR is
6. Note the position of the
Unlock Lock
flat side of the D-ring.
Insert the screw clasp with
the grooved screw clasp
inside and the flat side on
the outside of the strap.
Use a coin to tighten
the screw. (Refer to the
opposite side that has
already been assembled.)
now assembled.
Cordloc wheel before
adjusting. Slide the
wheel down away from
the strap to unlock the
Cordloc and slide the
wheel up towards the
strap to lock the Cordloc.
53