Dogtra TOM DAVIS 640C Manual De Instrucciones página 30

Cordloc
Cordloc
Wheel
Caution
Do not pull and lock the Cordloc too tightly as it may be
uncomfortable for your dog.
54
7. To tighten the BUNGEE
COLLAR, hold the end
of the bungee and pull
the Cordloc towards the
strap.
8. To loosen the BUNGEE
COLLAR, hold the bungee
near the strap and
press the Cordloc wheel
towards the end of the
bungee.
9. In order to fully lock the
strap and Cordloc, pull
the two parts in opposite
directions. Move the
Cordloc wheel up to lock
the Cordloc.
4. Receiver Fitting
Proper Fit
The receiver should be fitted so that the medical grade
stainless steel contact points press firmly against
the dog's skin. You should be able to fit two fingers
underneath the collar strap. The best location is on either
side of the dog's windpipe. After putting the BUNGEE
COLLAR on your dog, make sure that is is properly
locked.
Improper Fit
A loose fit can allow the receiver to move around on the
dog's neck. When this happens, the contact points may
rub against the skin and cause irritation. If the receiver is
too loose, the contact will not be consistent and cause the
corrections to be inconsistent. Dogtra uses medical grade
stainless steel contact points and anti-microbial plastic to
protect the dog's skin.
55