Publicidad
Idiomas disponibles
Idiomas disponibles
Sterilize the Scanner Tip
Scanner Tips shipped non-sterile. You must sterilize them before use.
CAUTION: If you limit the exposure time at 134° C to not more than 6 minutes, you can autoclave the
Scanner Tip up to 60 cycles.
To sterilize the Scanner Tip, follow these steps:
• Put the Scanner Tip into a sealed steam sterilization pouch.
• Place the Scanner Tip in a steam autoclave for sterilization.
– For TP102N and TP103N, exposure temperature should be set as 134° C.
– For TP102N and TP103N, exposure time should exceed 3 minutes.
– For TP102N and TP103N, exposure time should not exceed 6 minutes.
Precautions before use
Perform the following activities on your product and accessories before use.
Visually Inspecting the Scanner for Damage
Visually inspect the scanner for damage or signs of deterioration by doing the following:
• Inspect the Lens Window.
– Inspect around the buttons and contact points.
If damage is noted, do not use the scanner and contact your representative.
Visually Inspecting the Scanner Tip
Visually inspect the Scanner Tip for signs of deterioration by doing the following:
– Verify that the Scanner Tip is not damaged, and its components are not detached.
– Verify that the Scanner Tip mirror does not have any smudges or scratches on it.
If deterioration is noted, replace the Scanner Tip.
WARNING
• The Lens Window on the scanner is a delicate optical component. Mount the front Protective Cover
to protect the Lens Window from damage and dirt when the scanner is not in use.
• The mirror in the Scanner Tip is a delicate optical component. Its clean and undamaged surface is
critical to scan quality.
In the event that you see poor scan quality or an unclear video preview in the software, clean the
Scanner Tip mirror and the Lens Window of the Handpiece using a microfiber cleaning swab, applying
ethanol that is free of impurities.
1 8
NeoScan™ 2000 Installation and operation manual // Maintenance
Publicidad
