Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4: Operation
9,
Start
engine
according
to instructions
given in engine
owner's
manual.Also
see operating
instructions
tag
located
on the pressure
washer.
WARNING
. When
starting engine, pull cord slow.ty undJ resistance is felt
and then pull rapidly to avoid kickback.
if engine starts and fails to continue
to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spray gun.
NOTE:
Always
keep the throtde
lever
in the "Fast"
>osition
when
operating
the pressure
washer.
WARNING
, DO NOT touch hot surfaces,
Allow equipment
to cool before touching.
The pressure washer must be at least 5 feet from structures
having combustible
walls and/or other combustible
materiais.
, Keep at least 3 feet of clearance on all sides of pressure
washer
for" adequate cooling, maintenance
and servicing.
, in the State of California
a spark arrester
is required
by bw
(Section 4442 of the California
PuNic Resources Code). Other
states may have similar laws. Federal laws apply on federal
lands, if you equip the muffler
with a spark arrester; it must be
maintained
in effective working
order:
Now
to
Stop
Your
Pressure
Washer
I.
Let engine
idle for two
minutes.
2.
Turn
engine
off according
to instructions
given in
engine
owner's
manual
3.
Squeeze
trigger
on spray
gun
to relieve
trapped
pressure
in hose
to avoid
injuryo
NOTE:
A small amount
of water
will squirt
out when
3ressure
is released,
WARNING
Keep high pressure hose connected
to pump and spray gun
whiie system is pressurized,
Squeeze trigger on spray gun to relieve trapped pressure,
every time you stop engine. Engage trigger lock on spray gun.
4.
Engage trigger lock on spray gun when not in use,
Publicidad
