Publicidad
Idiomas disponibles
Idiomas disponibles
3. Installation notes.
1. When installing the water pipes, cannot install a drain stopper, in addition,
for the water pipe bottom connector, the screw nut should have no wire teeth
exposed.
2. If the inlet water pipe is 9 mm, should ensure that the inlet water tube and
connector have 30-40 cm of straight piping to avoid burst pipe accidents
caused by bending in the pipe.
3. If the power cord wiring needs to be longer, then according to the wiring
requirements use a Ø8mm pinched tube to wrap around the connection, then
on the outside wrap around insulating electrical tape, do not place it on the
floor, it should be suspended in the air or in another place away from the
ground.
4. When installing, if you need to make a hole in the wall, you should first
make sure that there are no electricity or water lines in the location you plan
to drill.
5. This machine must be connected to the safety socket that has the earth wire.
Otherwise the manufactory should not be responsible for any accident.
6. This machine is installed with the adaptor, it must not touch in much water
when installing, otherwise it would cause the electrical accident.
10. ADJUSTMENT METHODS
After confirming that the water route connections are correct, confirm that
you have a power supply and/or water supply. Then follow these steps to
troubleshoot the machine:
Av. de Velázquez s/n
(Cruce Aeropuerto) 29004 Málaga
www.baezaonline.com
Atención al cliente 951 91 91 21
Publicidad
