Publicidad
Idiomas disponibles
Idiomas disponibles
1. Open the tap water inlet valve as well as the water purifier inlet water ball
valve, plug in the power source (see diagram 7), close the storage tank ball
valve, then automatically start a 120 second flushing process, water will start
to drain through the discharge outlet.
2. Wait for the water purifier to operate stably (about 5-10 seconds), check
each connection to make sure it is secure, see if there is any leakage from the
membrane Shell, filters, etc.
3. Close the pure water gooseneck faucet and storage tank ball valve, wait
approximately 30 seconds, check whether or not the water purifier waste
water has stopped.
4. Open the gooseneck faucet, observe whether pure water is flowing through
the faucet, if no pure water is flowing, check whether the tap water pressure
is too low or whether the high pressure switch cannot be reset.
5. Wait until the machine is operating, closet he inlet water ball valve, after a
short time observe whether it has stopped operating, is it has stopped
operating, check the whether the low-voltage switch can be reset.
6. Wait some time to make sure everything is correct, then the water purifier
can be used safely.
11. USAGE METHODS
1. The major components of this product are plastic, then the using the
product always observe the integrity of the water purifier to ensure safe use.
2. In order to prevent microbial contamination of membrane components
during storage and transportation the reverse osmosis membrane element
package contains a small amount of protective solution while the post-
activated carbon filter will emit activated carbon power the first time it is
used. So for the first hour the water purifier is operated, do not open the water
storage tank. It is recommended that the water produced is thrown out,
otherwise the pure water taste may be unusual.
Av. de Velázquez s/n
(Cruce Aeropuerto) 29004 Málaga
www.baezaonline.com
Atención al cliente 951 91 91 21
Publicidad
