Lenco MC-160 Manual Del Usuario página 15

System set up available at DAB mode only
Automatic stand-by for power saving (CE regulation): The MC-160 will go automatically in standby if there is
no audio signal (record or Bluetooth) during ~ 10 minutes at below situation:
1. USB mode: Playback under pause or stop
2. Bluetooth mode: no connection, playback under pause
3. AUX mode: no incoming signal
4. Phono mode: Turntable stop rotation
5. Any mode: Volume level is 0
You can reactivate the system by pressing the STANDBY/VOLUME Knob or standby key at remote control.
HOW TO REPLACE THE NEEDLE
To replace the needle, please refer to the instructions below.
Removing the needle from the cartridge
1. Place a screwdriver at the tip of the stylus and push downward as shown in direction "A".
2. Remove the stylus by pulling the stylus forward and pushing downward.
Installing the Stylus
1. Hold the tip of the stylus and insert the stylus by pressing as shown in direction "B".
2. Push the stylus upward as in direction "C" until the stylus locks into the tip position.
NOTES
We advise you to clean your records with an anti-static cloth to gain maximum enjoyment from them.
We would also point out that for the same reason your stylus should be replaced periodically (approximately
every 250 playback hours)
Guide Pins (inside)