Lenco MC-160 Manual Del Usuario página 9

SET UP
An AC/DC adaptor with an output of 12V DC 2.0A is included with this Turntable system with Bluetooth
reception and Wooden Speakers. The adaptor is required for operating the unit.
Connect the speaker cables from each speaker to the back of the unit
Note: The external speaker cables are color coded, the cable with the red connector should be put in the red
hole and the white one in the white hole.
Extend the antenna at the back of the unit to get the best DAB/FM reception.
Firmly and securely insert the DC plug of the adaptor to the DC IN Jack on the back of the unit.
Plug the adaptor's AC plugs into a power outlet rated at 220-240V AC~ 50 Hz. The turntable system would be at
standby mode with display ON.
The system will get the time/date information from the air. If success, the display would show the time and date
information, you can press the Functional knob to show the weekday at the display. You can also set the date
and time manually. (Refer to SYSTEM SET UP section)
Remark: To avoid Larsen effect or Feedback noise, you can do the following:
1.
2.
Battery installation (Remote Control):
1. First time use use the remote
Remove the plastic protected sheet
2. Replacing battery (Lithium CR2025)
- Pull battery out of battery compartment.
- Insert new battery.
- Close cover.
CAUTION!
- Remove battery when it has been depleted.
- Batteries contain chemical substances, dispose of them properly and
avoid expose to excessive heat such as sunshine, fire or the like
- Danger of explosion if battery is incorrectly replaced.
- Replace only with the equivalent or same type.
Put your speakers at minimum distance of 60 cm or more from your turntable
Let the dustcover open when you play a record at higher sound volume