Publicidad
Idiomas disponibles
Idiomas disponibles
Starting the Heater: (Ignition)
1. Fill the tank with kerosene or other approved fuel
until needle on fuel gauge points to "F".
2. Replace fuel cap and tighten firmly.
3. Connect the heater to a three prong
(grounded) power source. You must use a
three prong (grounded) extension cord that is at
least 6 feet long and is a minimum of 14 AWG
rating.
Model 45-KFA:
1. Complete steps 1-3 above.
2. Move power switch to "On" position. The power
indicator light will illuminate and the heater will
ignite.
Stopping / Restarting Heater:
- To stop the heater, move the power switch to the "Off"
position and unplug the power cord.
- To restart the heater; wait 10 seconds and follow
ignition steps.
TIP: If the heater does not ignite; move
switch to "Off" position, check steps 1-3
above and then move switch to "On" position.
Models 75T-KFA - 215T-KFA:
1. Complete "starting heater ignition" steps 1-3
above
2. Turn thermostat control knob to desired
temperature setting. The thermostat set range
is from 40 ºF to 110 ºF.
3. Move power switch to "On" position. The power
indicator light and room temperature display will
illuminate and heater will ignite.
NOTE: 45-75T-KFA models do not have a room
temperature display feature.
The room temperature display will indicate the
following:
- When the temperature is less than 0 ºF the
display says "LO".
- When the temperature is more that 99 ºF the
display says "HI".
- Between 0 °F and 99 °F the display shows
actual temperature.
© 2017, Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING
OR WHILE CONNECTED TO A POWER SOURCE
Operation
Stopping / Restarting Heater:
- To stop the heater, move the power switch to the "Off"
position and unplug the power cord.
- To restart the heater; wait 10 seconds and follow
ignition steps.
heater ignites. If the heater does not ignite; move
switch to "Off" position, check steps 1-3 above
and then move switch to "On" position.
Long Term Storage:
Models 45-KFA - 75T-KFA:
1. Use an approved siphon to drain fuel through the
Models 135T-KFA - 215T-KFA:
1. Drain fuel through the drain plug in the bottom
2. To remove the drain plug, pull the plug grip
3. Using a small amount of kerosene, rinse and
4. To replace the drain plug; push the drain head
IMPORTANT: Never store leftover kerosene between
seasons, using old fuel can damage heater.
6
TIP: If the heater does not ignite, the
thermostat may be set too low. Turn the
control knob to a higher setting until the
fuel cap opening.
of the fuel tank.
downward and remove the seal head from the
drain hole in the tank.
swirl the kerosene inside of the fuel tank, empty
the tank fully.
fully into the drain hole and secure by pushing
the seal cap fully into the head hole.
Kerosene Forced Air Heater User's Manual
Publicidad
