Operation; Setting Up The Machine - Festool KAPEX KS120 REB Manual De Instrucciones

English
you can fold out the page for comparison and
quick reference.
7

Operation

WARNING
Unauthorised voltage or frequency!
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the machine's name
plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
must be used.
Before initial operation
Remove the transport safety device [3.1] on
–
the guide rod.
3
Switching on/off
– Press the on/off switch until you feel re­
sistance in order to unlock the saw unit and
the pendulum guard.
Press the safety lock [1.3].
–
Press the on/off switch [1.2] all the way in
–
to switch on the machine.
– Release the on/off switch again to switch
off the machine.
7.1

Setting up the machine

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
Install the machine on a level and stable work
surface before using it (e.g. the UG-KAPEX un­
12
3-1
derframe, the MFT multifunction table or a
workbench).
You have the following installation options
Screws: Use four screws to secure the machine
to the work surface. Use the holes [4.1] at the
four support points on the saw table to do this.
Fastening clamps: Use four fastening clamps
to secure the machine to the work surface. The
flat surfaces [4.2] at the four support points on
the saw table can be used as clamping surfa­
ces.
Clamping set (for MFT): Secure the machine
onto the Festool MFT multifunction table using
the clamping set [4.4, 494693]. Use the two
screw holes [4.3] to do this.
4.4
4.1
4a
4.2
4b
4.3
4c