Descargar Imprimir esta página

Cutting Depth Limiter; Special Cutting Position - Festool KAPEX KS120 REB Manual De Instrucciones

Ocultar thumbs Ver también para KAPEX KS120 REB:

Publicidad

Idiomas disponibles

Idiomas disponibles

13
8.9

Special cutting position

Besides the usual position for cutting or trim­
ming boards/panels, the machine has a special
cutting position for trimming slats with heights
of up to 4-3/4" (120 mm).
► Pull the saw unit forwards.
► Swivel the lever [14.3] downwards.
► Push the saw unit back until the metal
bracket [14.1] hooks into the rear opening
of the saw unit.
► In this position, you can now trim slats of up
to 4-3/4" (120 mm) in height at the stop. The
pull function and the vertical swivel function
of the mitre saw are deactivated, however.
► To bring the machine back into its standard
position, press the release lever [14.2] and
pull the saw unit forwards. This will unhook
the metal bracket [14.1] and the lev­
er [14.3] will swivel back.
14
14.1
13.1
13.2
13.3
13.4
14.3
14.2

8.10 Cutting depth limiter

The continuously adjustable cutting depth limit­
er can be used to set the vertical swivelling
range of the saw unit. Doing this enables work­
pieces to be grooved or faced.
Be aware of the limited grooving
range: Continuous adjustment is only
possible within the range 0 to
1-12/16" (0 to 45 mm). The possible
length of the groove is also limited.
E.g.: At a groove depth of 1-14/16"
(48 mm) and a workpiece thickness of
3-1/2" (88 mm), this range lies be­
tween 1-1/2" and 10-5/8" (40 and
270 mm).
► Move the machine into the working position.
► Swivel the lever for the cutting depth limit­
er [15.1] downwards until it clicks into
place. The saw unit can now be swivelled
down only as far as the preset cutting
depth.
► Set the cutting depth you would like by turn­
ing the cutting depth limiter lever.
► To deactivate the cutting depth limiter,
swivel the cutting depth limiter lever back
up again.
15
8.11 Fixed horizontal position
You can clamp the saw unit in place in any posi­
tion you want along the guide rods [15.3] using
the rotary knob [15.2].
8.12 Switching on the laser
The machine has two lasers which mark the
kerf to the left and right of the saw blade. You
English
15.1
15.2
15.3
17

Publicidad

loading