Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
TO AVOID
SERIOUS
INJURY,
BEFORE
PERFORMING
ANY
SERVICE
OR ADJUSTMENTS:
1.
Depress
brake
pedal fully and set parking
brake.
2.
Place
attachment
clutch
in "DISENGAGED"
position.
3.
Turn ignition
key to "STOP"
and remove
key.
4.
Make sure the blades
and all moving
parts have completely
stopped.
5.
Disconnect
spark
plug wire from spark
plug and place
wire where
it cannot
come
in contact
with plug.
TO REMOVE
MOWER
1.
Place
attachment
clutch
in "DISEN-
GAGED"
position.
2.
Lower
attachment
lift lever to its lowest
position.
3.
Roll belt off engine
pulley
(M) and belt
keepers
(G).
4.
Remove
retainer
spring
(K), slide
collar
(L) off and push
housing
guide
(P) out
of bracket.
5.
Remove
clutch
cable
spring
(Q) from
idler arm (R).
6.
Disconnect
front
link (E) from
mower
-
remove
retainer
spring
and washer.
7.
Go to either
side of mower
and discon-
nect
mower
suspension
arm
(A) from
chassis
pin (B) and rear lift link (C) from
rear mower bracket
(D) - remove
retainer
springs
and washers.
CAUTION:
After rear lift links are discon-
nected,
the attachment
lift lever will be spring
loaded.
Have a tight grip on lift lever
when
changing
position
of the lever.
8.
Slide mower
out from under right side of
tractor.
IMPORTANT:
If an attachment
other
than
the mower
is to be mounted
on the tractor,
remove
the front
link
(E) and rear
lift liks
(C) from tractor
and hook the clutch
spring
(Q) into the cable
guide
on front
edge
of
lower
dash.
TO INSTALL MOWER
Be sure tractor is on level surface and engage
parking
brake,
1.
Lower
attachment
lift lever to its lowest
position.
CAUTION:
Lift lever
is spring
loaded.
Have a tight grip on lift lever, lower
it slowly
and engage
in lowest
position.
NOTE:
Be sure
mower
side
suspension
arms (A) are pointing
forward
before
sliding
mower
under tractor.
2.
Slide mower
under tractor
until it is cen-
tered
under tractor.
03042tex
22
Publicidad
