3. PARTS IDENTIFICATION
1
Cabinet
2
Shelf
3
Foot
4
Upper hinge
5
Door gasket
6
Door
7
Low hinge
4. START THE PRODUCT
1) Remove the product from the packaging
2) Place it in the correct position on a flat and stable surface, a short distance from an
electrical socket and protected from direct solar radiation
3) Ensure there is at least 20cm of clearance from surrounding surfaces in all directions
4) Ensure an uninterrupted path of the air from below to the top passing through the
rear part: only the effective expulsion of the heated air guarantees the expected
performance, therefore it is necessary to ensure the formation of an air current by
exploiting the " chimney principle" as described in the figure