Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Thank you for choosing the Prestige Medical OMEGA 121/134 Autoclave, designed to sterilize solid,
un-wrapped instruments. After removing from the box, please check for any transit damage. If any
damage to the unit is found, please contact your supplier immediately.
Together with this unit and operating manual, you will find the following:
Key to Pictures, Diagrams and Symbols
The following descriptions refer to the pictures of the controls, display lights and operating symbols on
Page 3 of this manual.
Controls:
A -
Depressurization Valve
B -
Power supply switch "on/off"
C -
Temperature selection button
"121˚C or 134˚C sterilizing cycle"
D -
Lid interlock/cycle start button
E -
Fault mode/buzzer reset button
F -
Temperature Gauge
G -
Display panel
H -
Pressure gauge
I
- Operating symbols
J
-
Fuses and mains cable socket
Display Lights:
L1 -
Fault mode - illuminates RED and
flashing RED
L2 - Lid status - illuminates ORANGE, GREEN
and flashing GREEN
Before using the autoclave for the first time please take time to read the following pages to familiarise
yourself with the operation of the unit.
We strongly recommend that all users of the autoclave are trained in its operation.
The autoclave is very easy to use. By following this simple operating sequence in conjunction with the
pictures of the autoclave, it's controls, display panel and operating symbols (page 3), you will be able
to ensure your instruments are correctly sterilised every time.
1. Connection.
Attach the cable supplied to the rear of the unit
(J) and plug into an EARTHED mains electrical
socket of the CORRECT voltage.
Introduction
Electrical mains cord
Instrument furniture
Spare fuses x2 (when fitted)
Performance test certificate
Certificate of Compliance (230v models only)
Warranty registration card
Getting Started
L3 -
Sterilizing cycle completed - illuminates
GREEN
L4 -
Sterilizing temperature reached -
illuminates ORANGE
L5 -
Power to heating element - flashes
ORANGE
L6 -
Sterilizing cycle initiated - illuminates
GREEN
L7 -
Power to unit on - illuminates GREEN
Symbols:
S1 -
Do not use tap water or overfill
S2 -
Place lid in this position
S3 -
Rotate lid to secure
S4 -
Power switch
S5 -
Select temperature
S6 -
Press lid interlock/cycle start button
2. Water.
Fill the unit to the water level line on the inside of
the chamber with 0.75 litres of distilled or
de-ionised water (S1).
DO NOT USE TAP WATER OR OVERFILL.
4
Publicidad
