Publicidad
3. ATTACH THE HANDLEBARS
Push the handlebar pivot rod (52) through the support tube of the main frame (1).
Attach the left handlebar (25L) assembly to the left side of exposed ends of the handlebar
pivot rod (52). Do the same procedure for right side handlebar (25R) assembly.
Fix in position with one adjust washer (63),one washer (27) and one lock nut (17) for left
side handlebar. Note: Tighten the washer (27), lock nut (17) a little bit. Don't tighten it too much.
Do the same procedure for right side handlebar (25R) assembly.
After both side handlebar are fixed in position, please tighten the washers (27)
and lock nut (17) well. Note: These should be tightened fully to ensure that the
ends of the pivot rod (52) pass through the nylon insert in the locknut (17).
Fit the 2 plastic caps (26) over the locknuts when they are fully tightened well.
Moisten the inside of the foam grips (22) with a little water or houseold furniture
polish and slide onto both ends of the handlebar (25R/25L).
Attach lower handlebar (24) with linkage bar (10) to upper handlebar (25L) tighten with 2
bolts (68),2 curve washers (67) .
Do the same procedure to connect right handlebar (25R).
IMPORTANT NOTICE:
When you are ready to pedal the bike, please turn tension control knob (54) several circle with
counter-clockwise to decrease pedaling resistance. While pedaling, turn tension control knob
several circle with clockwise per your request to increase pedaling resistance.
4
4
Publicidad
