Using The Timer - Zibro SRE 440 E Instrucciones De Uso

G: The required
temperature on the
left, the measured
temperature on the right.
D
IGNITING THE HEATER
When used for the first time, a new heater may give out a smell for a short while.
You should therefore provide extra ventilation.
Always ignite the heater with the
lighter.
Just press the button
The button will start blinking, indicating that the ignition procedure has started.
This will take a short while. Once the heater is burning, the
lit (red). The information display ¹ will show two numbers (Fig. G). The actual
room temperature is indicated below ROOM, while the temperature setting is
indicated below SET. The latter can be changed with the adjustment keys (refer to
Section E).
Prior to igniting the heater, always check for sufficient fuel in the removable tank.
E
SETTING THE REQUIRED TEMPERATURE
The temperature setting can only be adjusted, when the heater is burning. Use
the adjustment keys
keys to switch on the function (the °C mark and 4-digit ¹ will start blinking). Next,
adjust the temperature using the key ( min.) to set the temperature to a higher
setting and the key ( hour) to lower the temperature. Press once to increase the
value one step. After approximately 10 seconds the °C mark and 4-digit will stop
blinking and the setting will be locked (Fig. F).
The available temperature settings range from 6°C minimum to 28°C maximum.
When the heater has been unplugged for more than 10 minutes (or after a power
failure), the temperature will reset to the factory setting of 20°C.
F

USING THE TIMER

The timer allows you to switch on the heater automatically at a preset time.
In order to switch on the timer, the correct time must have been set (refer to
Section C) and the heater should be off. Follow the procedure below:
1 Press the button
The TIMER light and the information display ¹ will start blinking.
2 Use the adjustment keys
Use the key ( hour) to set the hours and the key ( min.) to set the minutes
(interval of 5 minutes).
3 After approximately 10 seconds the information display will show CLOCK
again and the TIMER indicator light will light up, indicating that the timer
function has been activated (Fig. H).
4 The timer will ensure that the room will have been heated to approximately
the required temperature at the set time.
When you want to switch off the heater and ignite it again with the timer, all
you have to do is press the TIMER key (refer to Section G).
Press the button
button . Never use matches or a cigarette
to ignite the heater.
to adjust the temperature. First press either of the two
and then the TIMER key
to set the time at which the heater must ignite.
once to clear the timer setting.
button will remain
immediately after that.
4
79