Troubleshooting - IMER MIX 360 Manual De Uso, Mantenimiento Y Recambios

GB

12. TROUBLESHOOTING

. WARNING!
Switch the machine off by pressing the OFF pushbutton and di-
sconnect from power supply before carring out any maintenance
operations.
PROBLEM
- No power in the
supply line
- The electric plug
and socket are not
connected properly
- The cable from the
plug to the electric
panel is broken
- A wire has become
disconnected inside
(MIXER WITH
the panel
ELECTRIC MOTOR)
- A wire has become
The motor does not
disconnected on the
start when switched
motor terminal board
on.
- The pushbutton is
faulty.
- The protective cover
is open
- The limit switch is
faulty
- A wire has becone
disconnected inside
the limit switch
The endothermic
motor does not start
- The sealing gasket
is worn
The discharge outlet
leaks water
- The spring is broken
or ineffective
Scraper rubbers do
not mate with the - Worn rubbers
tank
The outlet will not
- Depositin the outlet
open protector
During mixing,
the paddle rpm - Belts are slack and
are slipping
decreases or
paddles stop
- There is no water in
the feed line
Water does not
arrive at the tank
- Water hose or valve
blocked
- Limit switch not
The blades do
mounted correctly
not stop when the
protection cover is
- Cam not mounted
raised
correctly
IMER INTERNATIONAL S.p.A.
CAUSE REMEDY
- Check the line
- Make a proper
connection
- Replace the cable
- Re-make the
connection
- Re-make the
connection
- Replace the
pushbutton.
- Close it
- Replace it
- Re-make the
connection
- See motor manual
- Replace the rubber
- Replace the spring
- Replace the
rubbers and/or
adjust their
position (11.3
MIXING PADDLE
REPLACEMENT)
- Remove and clean
the outlet(11.2
REMOVAL OF TANK
PROTECTION
COVER)
- Tension the
belts(11.4
TENSIONING
AND REPLACING
TRANSMISSION
BELTS)
- Change the feed
line
- Clean the hose or
valve
- Adjust position of
limit switch (11.1)
- Refer to limit
switch adjustment
instructions (11.1)
MIX 360
13. RESIDUAL RISKS AND SAFETY NOTICES
Although the machine is constructed in line with established legislation,
certain residual risks cannot be eliminated and require the use of indivi
dual safety equipment. The machine is equipped with notices to indicate
the residual risks and how to avoid them.
NOISE HAZARD
HAND CRUSHING/SHEARING HAZARD
EYE INJURY HAZARD
INCORRECT USE HAZARD
Read the manual before operating the machine
TRAPPING/CRUSHING AND SHEARING HAZARD
Do not touch drive components
ELECTROCUTION HAZARD
Note that the employer is responsible for ensuring his workers use indi-
vidual safety equipment.
CAUTION !!!
Keep the hands away from the outlet.
12
Wear ear defenders
Wear gloves
Wear safety glasses
Do not remove the guards
Danger - electrical power