Axxess GMOS-100 Instrucciones De Instalación página 24

Manually setting the radio type:
If the LED flashes do not match the radio you have connected, you must manually program
the ASWC to tell it what radio it is connected to.
1. To manually program the aftermarket radio turn "on" the ignition. Then press and hold
the "Volume Down" button on the steering wheel control until the LED goes solid red and
then release the "Volume Up" button.
2. Using the listing below press the "Volume Up" button the number of times (number is
to the left of the radio name) needed to program the correct radio type:
3. Press and hold the "Volume Down" button for 5 seconds to finish programming.
The LED will then go off.
4. After a few seconds, the LED will then blink the number of times corresponding to the
radio type. This number should be the same number that the "Volume Up" button had
been pressed.
Continue on next page
GMOS-100
Section 5
GMOS-100
1
Eclipse
2 Kenwood
3
Clarion "Type 1"
4 Sony/Dual
5
JVC
6
Jensen/Pioneer
7
Alpine
8 Visteon
9
Valor
10 Clarion "Type 2"
11 Metra OE
5.0