Danby DPA072B8WDB-RF Manual Del Propietário página 13

INSTALLATION INSTRUCTIONS
INSTALLING THE WINDOW KIT
The instructions below can be used for either a hung window or
a sliding window application.
1. Measure the window opening where the window kit will be
installed. Assemble as many sliders as necessary to fi t the
window. If the window opening is less than the minimum
length of a single slider, use the slider that has the hole in it
and cut it to the correct length. Make sure not to cut the end
that has the hole as this is necessary to attach the exhaust
hose adapter. Cut the adhesive foam seals to the correct
length for the window and attach them to the window sash
and frame.
2. Connect the window slider adapter to the window slider by
gently pressing it into the hole in the slider until it clicks into
place.
3. Attach the exhaust hose to the window slider adapter by
gently pressing it into the adapter until it clicks into place.
4. Install the slider kit and hose assembly and close the window
to hold it in place.
5. Attach the air outlet adapter to the back of the appliance
by sliding it down into the channel around the air outlet.
Attach the hose to the air outlet adapter on the back of the
appliance by gently pressing it into the adapter until it clicks
into place.
6. Cut the non-adhesive foam seal to match the width of the
window and insert it between the glass and the window
frame to prevent air and insects from getting into the room.
7. Install the security bracket in the window frame with the
provided screws.
Note: Do not over extend or bend the hose as this will impede
air fl ow.
12
1
B
A
A
2
3
4
5
6
7
B