Danby DPA072B8WDB-RF Manual Del Propietário página 22

OPERATING INSTRUCTIONS
WATER DRAINAGE
When the internal drain pan becomes full the appliance will beep
8 times and the digital display will show error code P1. The air
conditioning or dehumidifying action will stop but the fan may
continue to operate.
There are two methods to drain water from the appliance.
1. Drain Plug
1. Turn the appliance off and unplug it from the power source.
2. Carefully move the appliance to a location where the water can
be drained.
3. Remove the drain plug and allow the water to completely drain.
4. Replace the bottom drain plug, pressing fi rmly to ensure a tight fi t
and no leaks.
5. The P1 error symbol will disappear and the appliance will
resume regular function once power is restored.
2. Continuous Drain
During the Dry mode, you may wish to set up the continuous drain
option so that the appliance will automatically drain collected water.
Remove the exhaust hose during Dry mode, it is not necessary.
Ensure that the appliance is turned off and unplugged from the
power source before setting up the drain hose.
Remove the upper drain plug and attach the drain hose that was
provided with the appliance. Ensure that there are no kinks or bends
in the drain hose as this can stop water from draining.
Place the open end of the drain hose over the receptacle that the
appliance will drain into; this could be a basement fl oor drain, a
sink or similar.
Remember that there is no drain pump in this appliance, the
continuous drain is activated by gravity only. Ensure that the drain
hose goes straight down toward the fl oor from the drain connection.
If the hose is not positioned directly downwards, water will not drain
correctly.
21
1
2