Publicidad
Idiomas disponibles
Idiomas disponibles
Supplied accessories
Check and identify the supplied accessories.
1 AC power supply cord
(K2CB2YY00065)
1 FM indoor antenna
(RSAX0002)
1 Remote control
(N2QAYB000984)
Note:
•
Product numbers correct as of March 2023. These may be
subject to change.
•
The included Canadian French label sheet corresponds to
the English printing on the main unit and remote control.
Placement of speakers
The left and right speakers are the same.
Use only the supplied speakers.
You can cause damage to the system and decrease the
sound quality if you use other speakers.
Note:
•
Keep your speakers at least 10 mm (
system for proper ventilation.
•
Put the speakers on a flat safe surface.
•
These speakers do not have magnetic shielding. Do not put
them near TVs, PCs or other equipment easily influenced by
magnetism.
•
When you play at high levels for a long period, it can cause
damage to the speakers and decrease the life of the
speakers.
•
Decrease the volume in these conditions to prevent
damage:
–
When the sound is distorted.
–
When you adjust the sound quality.
CAUTION!
•
Use the speakers only with the recommended system.
If not, you can cause damage to the amplifier and
speakers and can cause a fire. Consult an approved
service personnel if damage occurs or if there is a
sudden apparent change in performance.
•
Do not modify the speaker or speaker wires as this
can cause damage to the system.
Making the connections
Connect the AC power supply cord only after all the
other connections have been made.
1
2
") away from the
13
32
3
2
3
Connect the FM indoor antenna.
Put the antenna where reception is best.
Adhesive tape
(not supplied)
Connect the speakers.
Red
Black
Be careful not to cross
(short-circuit) or reverse
the polarity of the speaker
wires as doing so may
damage the speakers.
Connect the AC power supply cord.
Do not use an AC power supply cord from other
equipment.
To household
AC outlet
Conserving power
The system consumes a small amount of power
(
"Specifications") when it is in standby mode.
Disconnect the power supply if you do not use the
system.
Some settings will be lost after you disconnect the
system. You have to set them again.
1
5
Publicidad
