Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing the media
Disc
1
Press [CD x] (main unit: [x]) to open the disc
tray.
Put in a disc with the label facing up.
Press again to close the disc tray.
2
Press [USB/CD] (main unit: [SELECTOR])
repeatedly to select "CD".
USB
Preparation
Before you connect a USB device to the system, make
sure you do a backup of the data.
1
Decrease the volume and connect the USB device
to the USB port.
Hold the main unit when connecting or disconnecting
the USB device.
2
Press [USB/CD] (main unit: [SELECTOR])
repeatedly to select "USB".
Note:
Do not use a USB extension cable. The system cannot
recognize USB device connected through a cable.
Bluetooth
®
You can connect and play an audio device wirelessly
through Bluetooth .
Preparation
• Turn on the Bluetooth feature of the device and put the
device near the system.
• Read the operating instructions of the device for details.
Pairing a device
█
Preparation
If this system is connected to a Bluetooth device,
disconnect it (
"Disconnecting a device").
1
Press [
].
If "PAIRING" is shown, continue with step 3.
2
Press [PLAY MENU] to select "PAIRING" and then
press [OK].
3
Select "SC-PM700" from the Bluetooth menu of
the device.
If prompted for a passkey, input "0000".
The device connects with this system automatically
after pairing is complete.
The name of the connected device is shown for a few
seconds.
Using the main unit
1
Press and hold [–
PAIRING] until "PAIRING" is
shown.
2
Select "SC-PM700" from the Bluetooth
the device.
Note:
You can pair up to 8 devices with this system. If a 9th device is
paired, the device that has not been used for the longest time
will be replaced.
Connecting a device
█
Preparation
If this system is connected to a Bluetooth device,
disconnect it (
"Disconnecting a device").
1
Press [
].
"BLUETOOTH READY" is shown.
2
Select "SC-PM700" from the Bluetooth menu of
the device.
The name of the connected device is shown for a few
seconds.
3
Start playback on the device.
Note:
•
A device must be paired to connect.
•
This system can only connect to one device at a time.
•
When "BLUETOOTH" is selected as the source, this system
will automatically try to connect to the last connected
device. ("LINKING" is shown during this process.)
Disconnecting a device
█
While a Bluetooth
device is connected
®
1
Press [PLAY MENU] repeatedly to select
"DISCONNECT?".
2
Press [R, T] to select "OK? YES" and then press
[OK].
"BLUETOOTH READY" is shown.
To cancel, select "OK? NO".
Using the main unit
Press and hold [–
PAIRING] until "PAIRING" is
shown.
Note:
A device is disconnected when you:
–
Select a different source.
–
Move the device out of the maximum range.
–
Disable the Bluetooth transmission of the device.
–
Turn off the system or the device.
®
menu of
7
Publicidad
