Descargar Imprimir esta página

Tunturi Cardio Fit Bike 30 Manual Del Usuario página 17

Ocultar thumbs Ver también para Cardio Fit Bike 30:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 64
Console (fig F)
1
3
2
1.
Display
2.
Tablet/ book support
3.
Buttons
⚠ CAUTION
Keep the console away from direct sunlight.
Dry the surface of the console when it is
covered with drops of sweat.
Do not lean on the console.
Only touch the display with the tip of your
finger. Make sure that your nails or sharp
objects do not touch the display.
‼ NOTE
The console switches to standby mode when
the equipment is not used for 4 minutes.
Explanation Display functions
Time
- Without setting the target value, time will count
up.
- When setting the target value, time will count
down from your target time to 0 and alarm will
sound or flash.
- Without any signal being transmitted into the
monitor for 4 seconds during workout, time will
STOP
- Range 0:00~99:59
Speed
- Displays current training speed.
Maximum speed is 99.9 KM/H or ML/H.
- Without any signal being transmitted into the
monitor for 4 seconds during workout, SPEED
will display "0.0"
RPM
- Displays the Rotation Per Minute.
Display range 0~15~999
- Without any signal being transmitted into the
monitor for 4 seconds during workout, RPM will
display "0"
WATTS
- Display current workout watts.
- Range 0 ~ 999
LOAD
- Shows tension level setting, when adjusting
resistance, for 3 seconds.
Distance
- Without setting the target value, distance will
count up.
- When setting the target value, distance will
count down from your target distance to 0 with
an alarm sound or flash.
- Range 0.00~99.99
Calories
- Without setting the target value, calorie will
count up.
- When setting the target value, calories will
count down from your target calorie to 0 with
an alarm sound or flash.
- Range 0~9999.
‼ NOTE
This data is a rough guide for comparison of
different exercise sessions which cannot be
used in medical treatment
Pulse
- Current pulse will display after 6 seconds when
detected by the console.
- Without any pulse signal for 6 seconds, console
will display "P".
- Pulse alarm will sound when current pulse is
over the target pulse.
- Range 0-30~230 BPM
English
17

Publicidad

loading