Tunturi STAR FIT B100 BIKE Manual Del Usuario página 18

English
Use
Adjusting the support feet
The equipment is equipped with 8 angular end caps� If the
equipment feels unstable, wobbly, or not levelled well, these end
caps can be used to make the required correction�
- To level the trainer, turn the 8 angular end caps located on the rear
stabilizer tube�
- Each aspect sets the machine in a different height level�
‼ NOTE
• The equipment is most stable when it is as low to the floor as
possible� Therefore, start to level the equipment by turning all
support feet fully in, before turning out the required support feet
to stabilize and level the equipment�
Adjusting the horizontal seat position
The horizontal seat position can be adjusted by setting the seat to
the required position�
- Loosen the seat adjustment knob�
- Move the seat to the required position�
- Tighten the seat adjustment knob�
Adjusting the handlebar
The handlebar can be adjusted according to the height and the
exercise position of the user�
- Loosen the handlebar adjustment knob�
- Move the handlebar to the required position�
- Tighten the handlebar adjustment knob�
Power supply (Fig. E)
The trainer is powered by an external power supply� Refer to the
illustration to locate the trainer power input�
‼ NOTE
• Connect the power supply with the trainer before connecting it
to the wall outlet�
• Always remove power cord when
• machine is not in use�
Console (fig F)
1
3
2
1� Display
2� Tablet/ book support
3� Buttons
⚠ CAUTION
• Keep the console away from direct sunlight�
• Dry the surface of the console when it is covered with drops of
sweat�
• Do not lean on the console�
• Only touch the display with the tip of your finger� Make sure that
your nails or sharp objects do not touch the display�
‼ NOTE
• The console switches to standby mode when the equipment is
not used for 4 minutes�
Explanation Display functions
Time
- Without setting the target value, time will count up�
- When setting the target value, time will count down from your
target time to 0 and alarm will sound or flash�
- Range 0:00~99:59
Speed
- Displays current training speed�
Maximum speed is 99�99 KM/H
- Without any signal being transmitted into the monitor for 3
seconds during workout, SPEED will display "0�0"
RPM
- Displays the Rotation Per Minute�
Display range 0~20~999�
- Without any signal being transmitted into the monitor for 3
seconds during workout, RPM will display "0"
Distance
- Without setting the target value, distance will count up�
- When setting the target value, distance will count down from your
target distance to 0 with an alarm sound or flash�
- Range 0�00~99�99
Odo
- Automatically accumulates the Total distance for all exercise
sessions�
- Range: 0�0 ~ 99�99 KM/ 0�00 ~ 9999 KM�
1 8